tags:- rgpv ece 5th sem micro processor syllabus, rgtu ece microprocessor syllabus, ece 5th sem microprocessor syllabus, rgtu ece 5th sem complete syllabus, rgpv ece 504 syllabus
Rajiv Gandhi Technological University,Bhopal(MP)
B.E. Electronics & Communication Engg.
Semester :-V
SUBJECT :-MICROPROCESSOR,MICROCONTROLLER AND EMBEDDED SYSTEMS
Revised Syllabus and Scheme of Examination
Effective from July 2010
MICROPROCESSOR,MICROCONTROLLER AND EMBEDDED SYSTEMS
Unit -I
Microprocessor 8086 Architecture -:BIU and EU, Registers, Pin Diagram, Memory Addressing, Clock Generator 8284, Buffers and Latches, Maximum and Minimum Modes.
Unit -II
Addressing Modes,: Instruction set of 8086, Assembly Language Programming, Assemblers, Procedures, Macros, Interrupts, 8086 Based Multiprocessor Systems - Coprocessors (8087 NDP), Closely and Loosely Coupled Multiprocessor Systems (8089 IOP).
Unit -III
Interfacing Chips- IC 8155 (Static Ram with I/O Ports and Timer), 8755 (EPROM with I/O Ports), 8251A (USART), 8255A (Programmable Peripheral Interface), 8253/8254 (Programmable Interval Timer/Counter), 8257 (DMA Controller), 8259A (Programmable Interrupt Controller).
Unit -IV
Microcontrollers : Microcontroller 8051- Architecture, Pin Diagram, I/O Ports, Internal RAM and Registers, Interrupts, Addressing Modes, Memory Organization and External Addressing, Instruction Set, Assembly Language Programming, Real Time Applications of Microcontroller- Interfacing with LCD, ADC, DAC, Stepper Motor, Key Board and Sensors.
Unit -V
Embedded Systems:Introduction, Classification, Processors, Hardware Units, Software Embedded into System, Applications and Products of Embedded Systems, Structural Units in Processor, Memory Devices, I/O Devices, Buses, Interfacing of Processor Memory and I/O Devices, Case Study of an Embedded System for a Smart Card.
0 comments